Page 1 of 1
What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 1:36 am
by foxtrotraptor
Hello so I noticed I ran into a problem when I was opening my king tiger, I have a small set of screw drivers but the set I have is a bit short and the base is too wide to fit in to reach the screw and get it ot. I noticed on youtube a few poeple use a screw driver that is long and slim and has a Orange T handle. That would be perfect to work on my tanks but I havent been able to find any of those other than in a Hex style. anyone know where I can get these or better yet a link to purchance one, I looked on amazon but I havent had much luck.
much appriciated
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 3:09 am
by Wolverine Tanker
Go to Harbor Freight. They should have a similar one in stock.
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 3:29 am
by foxtrotraptor
oh your right, I have one that is not too far from where I live. Ill take a look. Thank you
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 12:33 pm
by RobW
If you avoid the changeable head style screwdrivers you should be fine. Magnetic ones are very useful for getting the screws in around the gear boxes.
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 10:53 pm
by foxtrotraptor
I looked but I didnt have any luck. EVerything was too big
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 10:58 pm
by PainlessWolf
Good afternoon,
www.micromark.com
regards,
Painless
Re: What tools do I need to work on my RC Tank
Posted: Thu Jul 06, 2017 11:06 pm
by foxtrotraptor
Ph awesome very helpful thank you sir