RC Tank Warfare community hobby forum

Anyone used these, do you need to mod the tank in anyway? Anyone got any pics of them fitted?

The transmission cover is a glue on. The exhaust armour plate you need to pop the mount that holds the exhaust end in piece as well as the original exhaust pipe cover.

Cheers, I can see where the two long bits go I think, inside the tracks at the front? But I don't know about the other part, do you have a pic of it the a tank?

MichaelC wrote:The transmission cover is a glue on. The exhaust armour plate you need to pop the mount that holds the exhaust end in piece as well as the original exhaust pipe cover.

The two pieces the final drive cover goes on the inside in the front, here is a pic of the exhaust armour cover on the real thing:

"INTAKE" , armoured cover , only used if not using the feifels.

Before you fit the two transmission covers I suggest you do a dry run and just slide them into position because you may find that to get a good fit you need to clip off the end and file a curve into the leading end.
Certainly all the ones I have fitted if you don't adjust them they don't fit behind the towing shackles.
Shaun.

Ok cheers, so that would be the late Tiger yes?

Aussie wrote:"INTAKE" , armoured cover , only used if not using the feifels.

Yes mate.