RC Tank Warfare community hobby forum

After spending a few years collecting parts I have enough bits to make a start on this project
First off is the helmet , this was done by applying the base colours with the airbrush and then adding all the scuff's and scratches topically with a paint brush ,
Still a bit to do but it's getting there

The EE-3 carbine is a resin kit , this was assembled, painted and weathered ,

trimmed the visor and got it fitted , next up is to try and fit the servo in so i can raise and lower the stalk remotely from a switch on the gauntlets , i have fitted and tested the two leds in the top of the range finder so the flash when the arm is lowered

Pretty cool!!

I definitely did not expect to see a 1/1 Boba Fett build thread on the RC tank site when logged in today but I am very very excited about it!

I thought I had accidentally logged in to the 501st forum when I saw this

Looking good

damn that's cool!! I built bobba fetts Slave 1 a good few years ago. but great job on what you have done!