Hi All...Burger_Patrol1 here.....
Back from the dead. Hope ya'll are doing well in spite of all the craziness that has transpired over the past couple years.
It has been awhile since I have been active. Unfortunately lifes crazy bologna has derailed me from my Hobbies.
Well, I am going to make an effort to put some time in on the
"Tamy T1 Face Lift" I started and had to mothball in mid production.
I hope i remember how to post stuff correctly. If I'm flubbing up please let me know & i will figure it out. Well here goes nothin...
I think where I left off was mounting the motors. I bought some new black cans from ETO Armor many moons ago and they have been sitting
in a box under my work bench. I tested them out and they still work. There is a noticeable size difference from the ones i was going to install
originally. I also had to make some mods to the base plate by drilling a couple new holes for the motor base as well as trim off a portion of the motor housing so it would not hit my Torsion Bar suspension springs.
- BIG SIZE DIFF IN OLD MOTOR vs BLACK CANS
- P3170001.JPG (91.71 KiB) Viewed 783 times
- EYE BALLING WHERE NEW MOUNTING HOLES NEED TO BE
- P3190002.JPG (92.95 KiB) Viewed 783 times
- HOLES PUNCHED OUT
- P3260004.JPG (88.14 KiB) Viewed 783 times
- SUSPENSION TO MOTOR CONFLICT
- P1010006.JPG (92.31 KiB) Viewed 783 times
- MARKED WHERE TO CUT HOUSING FOR PROPER FIT
- P1010007.JPG (86.76 KiB) Viewed 783 times
- HACK JOB
- P1010008.JPG (89.93 KiB) Viewed 783 times
- MOTORS DRY FIT, CLEARANCE IS GOOD
- P4240009.JPG (91.71 KiB) Viewed 783 times