RC Tank Warfare community hobby forum

Just bought this second hand.

I suspect that was the on/off switch hole.
Alwyn

It is an old 27 Mhz hull with the power switch operated from the side with the smoker and volume controls on the base, using a thin piece of offcut Plastic cut to shape you can glue it in place to blank it off.
Shaun.

There is an on/off switch underneath. It says A B C next to this hole. Some sort of modes, maybe from before it was 2.4?

AlwynTurner wrote:I suspect that was the on/off switch hole.
Alwyn

Maybe smoker switch not sure I would glue a piece of sheet plastic behind it like jarndice noted

Good morning,
Never, ever walk into a room filled with the usual suspects around here and lead off with "what's missing from this hole?" There are altogether way too many shananigan artists here with access to 3D printers.
regards,
Painless

Ok cheers, as long as I know I don't need it, I'll fill it.

jarndice wrote:It is an old 27 Mhz hull with the power switch operated from the side with the smoker and volume controls on the base, using a thin piece of offcut Plastic cut to shape you can glue it in place to blank it off.
Shaun.

It was from the early models. It was three different frequencys.
You could set three tanks as A, B and C and be able to battle without interference.

PainlessWolf wrote:Good morning,
Never, ever walk into a room filled with the usual suspects around here and lead off with "what's missing from this hole?" There are altogether way too many shananigan artists here with access to 3D printers.
regards,
Painless

OOOhhhhh............Mr Painless knows us far too well
Tat was very tempting, but even I wasnt game to go there on that !!