Page 1 of 1
3D printed Speakers
Posted: Sun Nov 20, 2016 9:54 pm
by maxmekker
Re: 3D printed Speakers
Posted: Sun Nov 20, 2016 9:56 pm
by Tankbear
Sounds great.
Any plans for 75mm speaker (visaton fr8)
Re: 3D printed Speakers
Posted: Sun Nov 20, 2016 10:14 pm
by maxmekker
Tankbear wrote:Sounds great.
Any plans for 75mm speaker (visaton fr8)
As soon a the tanks get bigger,

.
No but that can be looked into .

Re: 3D printed Speakers
Posted: Sun Nov 20, 2016 10:26 pm
by Tankbear
Modern tanks are bigger

Re: 3D printed Speakers
Posted: Mon Nov 21, 2016 3:19 am
by HERMAN BIX
The KV2 sounds exactly like a JSU152 I saw on a doco that some Russian old-mates were trying to get going after all these years abandoned in a suburban empty land plot.................
And it got going too

Re: 3D printed Speakers
Posted: Mon Nov 21, 2016 7:22 am
by maxmekker
HERMAN BIX wrote:The KV2 sounds exactly like a JSU152 I saw on a doco that some Russian old-mates were trying to get going after all these years abandoned in a suburban empty land plot.................
And it got going too

that is correct sir . I based the first 'russian' sound i made back for the TBS Benedini on that JSU Clip. Might not be correct, but atleas the KV2 desserved some agressive engine sound and that was Perfect .
For the KV1 I find it better to use the calmer T34 set made.
Re: 3D printed Speakers
Posted: Fri Nov 25, 2016 10:55 pm
by maxmekker
Another speaker ready for customer , and here is a little test video again
Sherman
challenger
Leo 2