Page 1 of 2
how do I get plastic Track off
Posted: Tue Aug 16, 2016 2:22 pm
by STEWART763
Can some one please tell me how to get the tracks off my Pantiger that I bought last night quite cheep
I need to look inside the thing there seems to be no pins to remove on the track
Stewart
I know now that Pan tigers are not cool 
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 3:23 pm
by afv
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 4:25 pm
by STEWART763
thank you I will have a read through I did see a yourube video but it's for the tracks with a rod of some sort in
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 4:47 pm
by silversurfer1947
Looking at the photo, there do appear to be pins recessed in the circle on the track links. There should be a something similar on the inside of the track. Have you tried driving one of these apparent pins out from the inside?
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 7:06 pm
by forgebear
you can also pop the cap off the front sprocket undo the bolt and then pop off the sprocket with the tracks in tact
dave
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 7:47 pm
by BarryC
forgebear wrote:you can also pop the cap off the front sprocket undo the bolt and then pop off the sprocket with the tracks in tact
dave
Would be my first choice!
Re: how do I get plastic Track off
Posted: Tue Aug 16, 2016 9:10 pm
by STEWART763
well I got the tracks off with some difficulty and there's not alot inside my Tank
I was hoping to maybe find a wire off because there's no sound now I know why
Re: how do I get plastic Track off
Posted: Wed Aug 17, 2016 2:37 am
by HERMAN BIX
Get yourself a 2.4gig radio kit. They are cheap, and a far cry better than your current internsls.
Also, easy to fit.
Should you later decide to move on from the Pantiger, the radio can be transplanted as required to perhaps upgrade another tank that has the olde RX18 set up, so nothing lost.
Your pan will run better, have sound, and still be the cost effective entry level tank to get you into the hobby.
Re: how do I get plastic Track off
Posted: Wed Aug 17, 2016 7:29 am
by forgebear
hi or you could make it a tiger 1 tank get a top deck and back panel to replace the one you have on it make a nice tiger tanks from it
dave
Re: how do I get plastic Track off
Posted: Wed Aug 17, 2016 9:24 am
by STEWART763
thank you both for that bit of info
Before I get into trouble again can I say what I'm saying in this section
I was thinking about looking for a sec hand Tiger that way I would have spares should I brake some thing
this is going to sound silly there's 2 Tigers on evilbay that I'm looking at and that could solve lots of problems but I'm also thinking buy a HL new Tiger and be done with it with or with out metal this and that
So do I buy a £80+ from Nitroteck or some where else that could be cheaper
I now know that there's some thing wrong with the £30 cheepy it's dose not like to turn L/R
as for the PAN TIGER I found a spring in the TX unit any one like to say where it goes it might be the reason the tank is not turning to good
or the Carpet is the problem
Stewart