RC Tank Warfare community hobby forum

Hi All.
I am fitting a tk22 to my elefant (tank). and I cannot find any fittings that will go on the three pin recoil or elevation
pins. as they are so very close together,
I am assuming that they run vertical when looking down on the board. and that only the two inner set of pegs are used.
looking at the clark tutorial is no help sadly.
Can anyone through any light on this problem.
Ant help would be great.
Cheers.
Wads.

They're for servo connectors, not molex type plugs

If you're using traditional elevation and traverse I belive you should attach them to the henglong 8 pin wiring loom (but don't quote me on that!)

Hi Everybody.
Futuba was the way to go. I must be getting stupid in my old age.
Many thanks for the info.
Cheers Wads.

Some times it's a real squeeze, my ibu2 with 6 servo plug on going to the rx is a real squeeze. Glad you got it sorted