RC Tank Warfare community hobby forum

..made a start on a new build...

ooooooooooooooohhh ! don't see them in war thunder ! good luck i am watching this build !

Nice to see something different in the builds, I will follow along with interest. Actually its looking pretty good already!

When you think there were 306 Brummbar built there is very little in the way of reference material available,
I assume because it was based on the Panzer 4 chassis, but it had a good reputation as an Assault Infantry Gun and was to be found in the West and the East as well as in Italy while in service.
I also shall watch this build with interest.
Shaun.

The lack of reference is proving to be a challenge..I got the kit 3rd hand with no instructions so placement of the details may be a bit hit or miss..

Good afternoon,
Here is a link which may be of use. ;o) Just maximize the photo in the center of the site and click through to see all around the vehicle.
regards,
Painless

http://www.olddogmodels.com/photo-etche ... 35021.html

I think the kit I have is for an early model as the parts I have which I presume are for the drivers compartment has a different vison slit, more like a tigers..

Frank, apologies,
Here is a similar setup of views for an Early-Mid vehicle.
http://www.griffonmodel.com/uploadpic/P ... 520317.jpg
regards,
Painless

Sir if you have the Tiger 1 type vision slit then you are right it is an early, these were mainly built onto the PZ4 "G" Chassis although a few were built onto the "E" or "F" Chassis, these early models frontal Hull armour was thinner than the later 80mm, at 50mm on top of the front Hull armour.
I know no more I fear,
As has already been said you are pretty much on your own.
Shaun.

Cheers guys...every little helps...