RC Tank Warfare community hobby forum

I am having trouble connecting my AR610 Receiver to IBU2 Pro board the 6 channels on the IBU board which one connect to the Throttle , aileron, elevator ,rudder only using the 4 Chanels for now
the tanks is a heng long Challenger 2 any help would be appreciated thanks

Hi You cant use the spectrum dx6i to control 6 channels because channels 5&6 are not full function channels on the spectrum radio . Ian sells a radio that controls all the channels and not to expensive.

regards pete

I hate it when receivers have names and not numbers

So try this typically (apart from planet radios)

Steering is 1 channel
Throttle is 2nd channel

So hopefully your descriptions should have steering, then throttle, etc

normally (depending on the radio mode)

IBU1 - rx 2
IBU2 - rx 1
3 -3
4-4
5-5
6-6

As you have a IBU2 Pro if you only connect first 4 channels turn off dip switch #6 otherwise you never start the engine

Ian.

Many Thanks Tankbear i now have Tnk CH1 to Rudder on receiver
Tnk CH2 to Throttle on receiver
Tnk Ch3 to Elevator on receiver
Tnk Ch 4 to Aileron on Receiver
Tnk CH 5 6 off
all works reasonable well except no reverse on Throttle
Thanks Again DavyT5

Make sure the throttle stick is in the centre and re-do the radio to IBU2 configurations.

Ian.

Once again many Thanks al now ok turret work in reverse I can change that on the Transmitter
Do you belong to the Manchester Tank Club if so Ill see you there Sunday ?
Regards Dave

Yes I be there, with your IBU2 base

http://www.philslittleworld.webspace.vi ... U2Pro.html

I did a little write up o this, hope this helps


Channel 1 = Throttle
Channel 2 = Rudder
Channel 3 = Elev
Channel 4 = Aile
Channel 5 = Gear
Channel 6 = Aux 1

Ian thought it was you Charles confirmed it have you a sound card etc
DavyT5

UPS have it scheduled for tomorrow delivery so will be posting the orders out Saturday and bringing along Sunday for you and Charles.

If you didn't know it's back at Hyde this Sunday.

Ian