Page 1 of 1
ElMod and HL Ultimate II G/B & Motorts
Posted: Wed Feb 10, 2016 5:53 pm
by BarryC
Reading through the installation instructions it makes note that "motors much be suppressed" I understand what that means.
My questions is; are the motors in the Ultimate II G/B set suppressed internally as they are not externally? Just want to make sure to get some caps to suppress them before time to install board.
Thanks,
Barry
Re: ElMod and HL Ultimate II G/B & Motorts
Posted: Sat Feb 13, 2016 4:43 pm
by MichaelC
Hey Barry,
I don't think any of the motors are internally "surpressed". Maybe other experts can jump in, but I think you will need to "cap" it externally if you so choose to. I never did understand the importance of putting caps on motor leads, I think it is suppose to filter out noise generated by the motor core in brush motors ?
MichaelC.
Re: ElMod and HL Ultimate II G/B & Motorts
Posted: Sat Feb 13, 2016 5:14 pm
by Tankbear
motors can be internally surpressed, although with out the motor data/instruction sheet it's not possible to comfirm with out taking apart.
Re: ElMod and HL Ultimate II G/B & Motorts
Posted: Sat Feb 13, 2016 5:18 pm
by MichaelC
Tankbear wrote:motors can be internally surpressed, although with out the motor data/instruction sheet it's not possible to comfirm with out taking apart.
Can you peek thru openings to see ? Also, what is the effect of not suppressing motors ? Would it contribute to some of the "Ghost in the machine" effects with regards to interference and odd behaviours ?