RC Tank Warfare community hobby forum

If anybody has the Taigen metal Panther lower..can you measure the inside width please? I am trying to see what size
speaker enclosure I can fit in there compared to my KT. I hear the length is about the same so no issue there. Thanks! Tom

Taigen doesn't have a metal hull on their Panther as of yet. Maybe Q2 or Q3 next year. I have the Asiatam and would be happy to measure it if you'd like Tao. I'll do it then update this post.


The hull is 4 3/8".

Joe, I think tao mean this one:

http://www.dklmrc.com/Panther_Metal_Low ... 19313.aspx

I had two of them but have since sold them both. Will be getting the new F shortly and I believe it has the same lower.

MichaelC.

I am trying to really squeeze in the largest speaker enclosure..do you think that one..the link is also 4 3/8? Or a tad smaller?

tao wrote:I am trying to really squeeze in the largest speaker enclosure..do you think that one..the link is also 4 3/8? Or a tad smaller?

I got mine from rctank.de but I would bet that they are the same as the one Michael posted.

Joe, they are the same. rctank.de has the exclusive and sells it to DKLM for re-sell.

MichaelC wrote:Joe, they are the same. rctank.de has the exclusive and sells it to DKLM for re-sell.

I didn't know they had the exclusive rights MichaelC, thank you.

Apparently IMEX will be carrying them next year or something like that (It is in their catalogue). I guess it make sense since they will also be selling their new Panther F which uses the same lower. Up until now, I know nobody carries it here in America and my dealer in Canada couldn't get them, and DKLM in Hong Kong got theirs via rctank.de. Both of mine were from Dom at rctank.de.

tao, here they are, interior shots of the Taigen Panther hull.
MichaelC.

Thanks! Same length as Tiger I or a bit longer? KT is quite a bit longer than Tiger.