RC Tank Warfare community hobby forum

hey guys,

it may seem silly but i cant get the hl pershing gears (plastic) out of the dam tank, ive un done the screws so the gearboxes are loose, ive taken of the tracks and used an alon key to take off half of each wheel, but after that im completely baffled

any help is greatly appreciated,

Matt

matt
the other half of the sprocket comes off and should leave a shaft

with the pershing you need to wiggle the boxes to get them out as they are a squeeze and the highest motor comes out first 

ok thanks mate ill give it a go!

Matt

i take it you want to remove the whole gearbox assembly

the sprockets might be a little stuck just turn the sprocket a little to free it off the flat of the shaft

I also removed the drive housing on the outside of the tank, it is held on by a screw at the top

as brel said matt ,you have to remove the gearbox housing
regards, ice

ahh gotya thanks guys came off a treat

cheers,

Matt

p.s. the aim of it was that ive swapped the metal gears in the bulldog with the plastic in the super p