RC Tank Warfare community hobby forum

My second tracked beasty!

While I was waiting on some bits for the Tiger, I thought I might make a start on the Sherman. This is basically going to be an out of the box build but with quite a few detail bits (thanks Bob!) I'm also going to replace the philips screws on the suspension units with hex bolts. Some thanks must also go to the Impact guys incl Mark from www.mitosal.com

Changes so far:

Bearings fitted in road wheels
Impact return rollers
Impact idler with D/P hull strengthener
Styrene back plate
Impact T/U's with Graupner 400 motors
Scratch built hull strengthener (fwd and above of T/U's)

great start, i bet the list grows 
regards, ice

nice work, what's your method of getting the tracks to look rusty

BREL wrote: nice work, what's your method of getting the tracks to look rusty

It's pretty easy.

Lay the tracks out on some old newspaper.
I mix up a sloppy batch of raw umber and raw sienna (artists acrylics) mixed with de-mineralised water and a drop of dish washing liquid.
Using a soft wide brush I then just paint it on one side then turn the tracks over and do the other.
Let it dry for 24hrs and there you have it!


I haven't tried to get a deep rust effect, just a dirty used look.

Hope this helps

Phill

thanks Phill just the information I needed

Hi The Tracks look to me like well used ones not rusty but mud dust and all the other stuff you would expect .Put this in the hints and tips section along with a couple of photos and a write up they are brilliant.

regards pete

Great choice with the Sherman, even the out off the box model is strong and reliable, i love the T-66 tracks they look so much better than the T-84's and i know i keep saying it but i will get some for mine just as soon as i have enough pennies

Keith

Some more progress. I modified the elevation unit by using epoxy on the clutched gear and wiring in some sub-micro switches in place of the metal elevator arm stops.

Hi Phill,

  Nice build . Im not sure if to make my Tamiya Sherman a Firefly as per the other post or a standard one now . I have the old model Sherman  like the other guy .And moneys tight so Im fitting HL electronics possibly RX18 not sure yet. I do have the Tamiya full option model but not sure if to alter that yet ? I shall be watching your work well done.

All the best Littletankman

Slow progress.....getting there tho!