RC Tank Warfare community hobby forum

Well, I decided to take the panther down from the shelf and do some upgrading rewire the electrics and now to install the Asiatam unit .. here goes.nothing Ray.

Looks like the dusting went well ray

Following along Ray

ALPHA

Me too...

Rayzzer,
I'm going to have to install on of these in a resin StuG casemate so following along as well.
regards,
Painless.

: Hi all it's getting a little tricky with no mounting for the swing arm don't think im going to install the high intense flash as I fitted led flash ages ago well it's all in bits fashioning the missing part of swing arm then should fit ..fingers crossed will take photos an post thanks for the interest.Ray.

rayzzer-b wrote:: Hi all it's getting a little tricky with no mounting for the swing arm don't think im going to install the high intense flash as I fitted led flash ages ago well it's all in bits fashioning the missing part of swing arm then should fit ..fingers crossed will take photos an post thanks for the interest.Ray.

RAY!!!....You can't run into problems now ....look how many are following



ALPHA

found some metal brackets look promising i could of cut an bent sheet metal to fit but thats not in my handbook if i can fiend something thats almost right then go with it,,, the mantlet on original HL" never elevated or depressed far enough for me '' so im going to get it to go all the way mg ''led dun .. just extensions from hull mg ''need to build something for the unit to sit flat on got a back plate to an old mfu which looks the right dimensions ,, the barrel is abou right lenth ,, so seams i have parts ,, now to put it together ""HERE GOES "",, Ray

Hi all .. Latest modified smoker of mine.going in ...working on the gun mounting at mo ..

Hi Ray, will be following this closely as I put an asiatam unit in my Panther but could only get about 10 degrees elevation and no depression, so if your setup works better I might have a go at redoing it