Simplified rewiring of HL Part 1

[shangovi]

hi - just joined up after reading this post of yours which is very informative for new comers like me. I am relatively new to RC tanks and have a HG Tiger 1 (non recoil) and made the mistake of buying a Tamiya turret with a recoil barrel then found out the two are not just plug and play so is it possible to connect the two? are there any wiring diagrams available?
Thanks in advance.

[Jofaur86]

viewforum.php?f=42
Good evening,
I think you forgot to go through the post "presentation"

[Jofaur86]

Hello,
what exactly did you buy in Tamiya? except a lot of work, it will be very difficult to adapt a Tamiya turret on an HL tank, which is mechanically different.It would be easier (personal opinion) to find an HL turret and RX plate in 2.4 Gh, cabling the same for an old 27 Mhz generation.

[jarndice]

hi - just joined up after reading this post of yours which is very informative for new comers like me. I am relatively new to RC tanks and have a HG Tiger 1 (non recoil) and made the mistake of buying a Tamiya turret with a recoil barrel then found out the two are not just plug and play so is it possible to connect the two? are there any wiring diagrams available?
Thanks in advance.

Your other post says Taigen Turret, It is quite important to know which you mean.

[shangovi]

Apologies for that it is indeed a Taigen turret with recoil main gun

[Jofaur86]

Hello
whether it is a Taigen system with the Asiatam canon recoil? there is no problem of adaptation, except maybe rewiring? for that it would take some photos of the existing one, to confirm (easier)
is this system?

665A29E3-60AC-4E74-A9CD-78BDDB1F37E4.jpeg (39.21 KiB) Viewed 1868 times

[shangovi]

https://www.taigentanks.com/collections ... tal-turret
This is the turret. I am still trying to figure out how to post pictures.
I will try my best to post some though...

[jarndice]

I could not help noticing that the instructions for the Taigen Turret warns against trying to match it to a Heng Long Tiger 1 unless you are prepared to get involved with some rewiring,

[john1970]

Do not use that on/off switch if you have a HL 6.0 board

[Jofaur86]

if I understand ? it is the Airsoft system with recoil of the barrel by servo? to operate with an RX 18 you need the following module, connected to the power supply, and take the most 5 volts on the small switch of the reversing system
https://www.rctank.de/Taigen-platine-de ... l-Servo-BB