Page 1 of 1
Tiny hinges required for sheens engine cover
Posted: Sat Oct 04, 2014 8:02 pm
by Shermie22
Hi I have cut out the engine panel in my tamiya Sherman. Where can I get tiny hinges for it from
Re: Tiny hinges required for sheens engine cover
Posted: Sat Oct 04, 2014 8:11 pm
by PainlessWolf
Good Afternoon,
If you know what size you need, Go and check out:
http://www.an-bri-rc-modellbau.de/epage ... 1737884026
regards,
Painless
Re: Tiny hinges required for sheens engine cover
Posted: Sat Oct 04, 2014 8:14 pm
by jarndice
Hi Shermie, if you go to a dolls house accessory web site you will be overloaded with choice, you can also get slide bolts and all manner of useful stuff, the drawdack is that this stuff is expensive.
shaun
Re: Tiny hinges required for sheens engine cover
Posted: Sun Oct 05, 2014 7:32 am
by HERMAN BIX
I was going to say the bl;atantly obvious place for complex small hinges would of course have to be a dolls house builders depot
Re: Tiny hinges required for sheens engine cover
Posted: Sun Oct 05, 2014 11:47 am
by jarndice
I had a feeling that would bring you out of the woodwork
What progress with the schlepper or with Summer coming are you "Waxing down your surf board" sorry about that but the Beach boys are a part of my generation.