RC Tank Warfare community hobby forum

Upon charging up my battery to max i noticed the lights on my Heng Long Tiger 1 were still flashing. So i read up on the causes of this and came to find out the crystal set had two different frequencies 26.690 MHz and 13.5725 MHz. I was just wondering if this is normal or the factory had messed up somewhere?

That's an interesting one.... usually the crystals are matched... and in general the only reason the lights would blink is because you didn't turn off the tank
Is there connection between the TX and Tank?
ALPHA

ALPHA wrote:That's an interesting one.... usually the crystals are matched... and in general the only reason the lights would blink is because you didn't turn off the tank
Is there connection between the TX and Tank?
ALPHA

There is no connection between the tank and the controller. and the rx on the tank was super hard to remove. Like i was thinking of just throwing it out of the window it was so hard. But after a 15 min struggle it was out.

VStrideUltimate wrote:

ALPHA wrote:That's an interesting one.... usually the crystals are matched... and in general the only reason the lights would blink is because you didn't turn off the tank
Is there connection between the TX and Tank?
ALPHA

There is no connection between the tank and the controller. and the rx on the tank was super hard to remove. Like i was thinking of just throwing it out of the window it was so hard. But after a 15 min struggle it was out.

If there is not communication between the two ... the crystals are definitely incorrect...get new ones from the dealer that you got it from...or if you are in the UK... Forgebear

ALPHA

Thanks, Alpha for your help, iv'e ordered a new set.

VStrideUltimate wrote:Thanks, Alpha for your help, iv'e ordered a new set.

No Problem VStride...that' part of the reason we are here ... help each other out best we can

ALPHA