Page 1 of 1
VVSS on Tamiya Sherman
Posted: Mon Sep 16, 2013 3:23 am
by cfredbandeira
Does anyone know hot to fit the Mato Metal VVSS suspension on the Tamiya Sherman? Any pictures?
Re: VVSS on Tamiya Sherman
Posted: Mon Sep 16, 2013 3:52 am
by PainlessWolf
Good Evening,
There are some amazing Tamiya Shermans in the Tamiya Build section of the Forum. I know some have used Mato Sherman hulls to great effect but if you peruse further, you may find the info you are looking for.
regards,
Painless Wolf
Re: VVSS on Tamiya Sherman
Posted: Mon Sep 16, 2013 7:27 am
by Ad Lav
Yes is the answer - forget who did it now but I looked good and solid.
Re: VVSS on Tamiya Sherman
Posted: Mon Sep 16, 2013 1:36 pm
by cfredbandeira
Thank you for your support. I wanto to fit the Mato metal VVSS suspension on the original Tamiya metal lower hull.
Re: VVSS on Tamiya Sherman
Posted: Mon Sep 16, 2013 2:14 pm
by forgebear
Re: VVSS on Tamiya Sherman
Posted: Tue Sep 17, 2013 12:20 am
by cfredbandeira
Thank you. It will help...
Re: VVSS on Tamiya Sherman
Posted: Sat Jan 11, 2014 2:03 am
by Warhawkone
Hi I did what your doing. If you know someone with a Bridgeport Mill they can place the holes where you need them. I have some pic of my tank on the site. Good luck Warhawkone.
Re: VVSS on Tamiya Sherman
Posted: Sat Jan 11, 2014 3:23 am
by ALPHA
Canned Heat did a conversion... but wasn't on a tamiya..
http://www.rctankwarfare.co.uk/forums/v ... 22&t=11626 I would think it's about the same..it just depends on your mounting points
GOOD LUCK
ALPHA