RC Tank Warfare community hobby forum

Today I set up the bracket to the suspension a Tamiya Panther.
The Panthers had a modified suspension, but could not bear the weight.
So I get the tub with the request to finally build a working suspension.

I started so I cut the parts and edit.

http://up.picr.de/14929037og.jpg

http://up.picr.de/14929038js.jpg

For the rods I use without changing the originals from Tamiya. Only in the holding the iron anvil must be drilled to 3mm.

http://up.picr.de/14929041bc.jpg

The axles do I do I solder the two parts together.

http://up.picr.de/14929039xs.jpg

http://up.picr.de/14929040km.jpg

These can then install that.

http://up.picr.de/14929042st.jpg

The springs I wrap myself with the help of a winch on my lathe, but caution, turn off the power .... ....

http://up.picr.de/14929044sm.jpg

http://up.picr.de/14929046jj.jpg

http://up.picr.de/14929043nf.jpg

As the driver on the axes I use collars with two M3 set screws to secure each terminal of the suspension. Here I drill the hole into which I put the springs.

http://up.picr.de/14929045wu.jpg

I can then put together control arms, axles, springs and collars.

http://up.picr.de/14929048do.jpg

Thus, the suspension can also be defined work I build aluminum brackets into the tub which hold them.

http://up.picr.de/14929050uw.jpg

So far as the suspension is finished and I can start to assemble the tub. Today I installed but only the transmission and tomorrow it goes on.

http://up.picr.de/14929051le.jpg