RC Tank Warfare community hobby forum

hi guys can anyone tell me how to remove one headlight & place the outher one in the centre of the hull on h/l tiger 1 allso how to fit a m/g in the turret . thanks tanker 242

I've covered the centre headlight in my Normandy Tiger post:

http://www.rctankwarfare.co.uk/forums/v ... =22&t=8350

As you can see there was a stage where they deleted the starboard (radio operator's) side headlight before adding the central light on the glacis...

As for a turret MG I can't see any reason why you can't wire up an extra LED to the hull MG circuit... Or did you mean the one on the cupola?

Hi Tanker ..........

I dont know if you mean replacing and fitting a fine detail Co-axial MG into the turret , but this is what I did a few years ago fitting
one to my Tiger 1 , it is currently stripped down ( a BB version at the moment ) so the pics are in its stripped down state.

First after removing the top from the hull and disconnecting the wires , remove these 3 screws from the turret ring



Then remove these screws from the under side of the turret



most of the (BB) unit will simply separate and come away , but remove these 3 elevation unit scres from inside the turret "bin"



Then to separate the plastic barrel ( if yours is a BB unit) remove this screw and the other one on the opposite side and slide off



Be carefull not to breal off the wires to the BB red warning light , it needs to be prized out of this socket




The green arrow indicates where the HL plastic turret MG was , this is the fine detail unit replacement



The replacement on this unit supplied by Welsh Dragon will fit straight in the original hole, simply use silicone sealent to bond




This is how it looks fitted from outside



For the wiring , this is soldered onto the corresponding coloured wiring of the hull MG / light board



These are the wires from the turret and how they pair up with the Hull MG



Hope that helps ?


Gordo

thanks guys that helps a bit but what i need to know is can u cut the wires to one headlight & move the outher to the centre .iff so witch wires to cut & witch light to move to centre, allso wildboar 44 are th two wires black & yellow in ur last photo for centre mounted headlight ?

I think the headlights are wired in serial, so just follow from the square board to the first one and use that one as your centre headlight. You can unsolder the second one from the first one. If yours is wired parallel (i.e. there is a set of wires going to each of the headlights from the square board) then just unsolder the one you are not using as centre.

Don't worry about the colour of the wires. Just make sure you keep the first one (if it is serial) and just unsolder one set from the board (if it is parallel).

For the turret MG just solder it the same way as the hull MG like wildboar's, if it doesn't work just switch them. Won't hurt anything.

Hi Tanker......

As MichaelC explains , it wont matter which light you cut the leads from , either one will be ok . you can move either
to the centre , just pick one, move it and disconnect the other .

Yes the small yellow and black leads are from a replacement scale size single central headlamp

thanks guys now i can carry on converting to mid war tiger 1 for whitmans tank . & fit co axel m/g into turret . tanker 242

have now repositiond one light to centre of hull & removed the outher & fitted turret m/gun , all working great , have kept one headlight as a spare ,& have fitted hull light with noteck cover made by cutting out a circle of plastic sheat & cutting a slot in it , tanker 242

What did you do with the old headlight mount on the hull sides ? I moved mine but haven't done anything to the old mounting points yet.

What did you do with the old headlight mount on the hull sides ? I moved mine but haven't done anything to the old mounting points yet.