HL M41A3 Problem - stuck on firing sequence
Posted: Thu Oct 25, 2012 12:04 pm
Hello Everyone!
Well I just received my first tank the Heng Long M41A3 Bulldog. Its the smoke/sound/bb version.
After unpacking it and reading through the manual I started it up for the first time and had a little drive around my room (all flat) twisted the turret a few times and tried firing twice (without bbs in).
I turned it off and switched smoke off (my room is small) and put some BB's in it then switched it back on.
I pushed the engine button and after starting, it immediately began the firing sequence (shooting sound, and motion, no BB. Like pushing the K button) and kept repeating this, not taking any further commands from the remote.
Here is a video of what I am talking about :
http://www.youtube.com/watch?v=dcID0v3cRFM
I took the top off the tank and had a look at hte electronics (board in the middle and board on the top hull aswell as making sure all the cables are connected. Nothing looks burnt out or dislodged on the boards, and all connections are in fine. I reseated the crystals and tried again but got the same result. THe video is after I put it back together.
Any ideas what might be wrong? should I send it back to the people I bought it off (luckily in the same country!)
Well I just received my first tank the Heng Long M41A3 Bulldog. Its the smoke/sound/bb version.
After unpacking it and reading through the manual I started it up for the first time and had a little drive around my room (all flat) twisted the turret a few times and tried firing twice (without bbs in).
I turned it off and switched smoke off (my room is small) and put some BB's in it then switched it back on.
I pushed the engine button and after starting, it immediately began the firing sequence (shooting sound, and motion, no BB. Like pushing the K button) and kept repeating this, not taking any further commands from the remote.
Here is a video of what I am talking about :
http://www.youtube.com/watch?v=dcID0v3cRFM
I took the top off the tank and had a look at hte electronics (board in the middle and board on the top hull aswell as making sure all the cables are connected. Nothing looks burnt out or dislodged on the boards, and all connections are in fine. I reseated the crystals and tried again but got the same result. THe video is after I put it back together.
Any ideas what might be wrong? should I send it back to the people I bought it off (luckily in the same country!)