Page 10 of 10
Re: Boosting a H.L. smoke unit
Posted: Thu Sep 24, 2015 11:22 am
by Muscleflex
Can I still buy this smoker? I know nothing about smoke units. Will it be ok for my tamiya tiger?
Re: Boosting a H.L. smoke unit
Posted: Thu Sep 24, 2015 1:11 pm
by ALPHA
Muscleflex wrote:Can I still buy this smoker? I know nothing about smoke units. Will it be ok for my tamiya tiger?
Of course you can get that smoker..check with forgebear....but really I would get the TARR 1...all metal construction and puts out ten times more smoke
Get new exhausts from forgebear...you'll need those
ALPHA
Re: Boosting a H.L. smoke unit
Posted: Thu Sep 24, 2015 3:26 pm
by Muscleflex
I'll contact him now. So I just ask for tarr 1 smoker unit with exhausts?
Re: Boosting a H.L. smoke unit
Posted: Thu Sep 24, 2015 9:38 pm
by ALPHA
Muscleflex wrote:I'll contact him now. So I just ask for tarr 1 smoker unit with exhausts?
I don't think he carries the TARR....he does carry the stock HL or Taigen units....The Tarr over there I'm not sure of...I got mine from Dgsselkirk...also a member here...not sure if he has any left...but you can try contacting him...or ask Forgebear if he can source them for you from him
ALPHA
Re: Boosting a H.L. smoke unit
Posted: Fri Sep 25, 2015 7:26 am
by Muscleflex
Thanks. Is it the TARR 1 or TARR mk2 I need to be looking at?
Re: Boosting a H.L. smoke unit
Posted: Fri Sep 25, 2015 11:49 am
by Muscleflex
Great! Thank you!
Re: Boosting a H.L. smoke unit
Posted: Sat Dec 05, 2015 3:23 pm
by sebbe335
Hello!
I have a problem with HL proportional board that im trying to work with my Tarr smoker.
I dont get the voltage out from the motors to the fan. I Think its like this that the voltage from the RX board is constant to the heater element and the voltage from the motors should affect the pump/fan when the voltage get over the RX board. But all i got when i measure at the fan Points when i got 8V from the motor Point is the voltage that same that came from the RX board. Hope you understand my problem. See Picture. Do i need to jumper some Point at the board??
//Sebbe
- boafrd.JPG (85.06 KiB) Viewed 2650 times