RC Tank Warfare community hobby forum

jarndice wrote:Thank you IAN, The thing about Windows 10 is it is not really built for a PC much more for a laptop which of course is used quite differently, If, I emphasise IF I buy a Laptop then Windows 10 would be fine but right now "7" is where I am staying.
Yet again thanks for the speedy reply.
shaun.

You never tried 8 then that was well random.

I use 7 at work and it's okay.

Ian.

Can you post a picture of the IBU2 and 3 side by side for size comparison ?

Hi Mike I’m all out of IBU2 at the moment so I try take a snap of one in my tiger 1.

Plan to do some videos this evening and share here.

Ian.

First video



This is a standard TARR mk2 and all I have done is wire the fan and heater separately and plugged into the IBU3

Okay next video.

IBU3 in my test tank (WSN T34) using 7.4v LiPo



The first cockrill sound signifies the system as powered up and ready to go.

Further cockrill sounds whilst driving are battery voltage levels (flat battery), you actually get different sounds to play but I was lazy and just used same sound file for all warnings.

Then beeping at end is the controller low battery LOL

Size next to IBU2

Into the beast now

Test run



Now this tank is heavy and has rubber pads on its tracks!

Also did some braking as well

I really like the new motor sounds! Do you think Ibu2's firmware will be updated to be able to play sounds like that?

Rad_Schuhart wrote:I really like the new motor sounds! Do you think Ibu2's firmware will be updated to be able to play sounds like that?

I don't know, I'll ask manufacturer. But even if it can be done it will be low priority until the IBU3 is fully launched and any issues rectified.