RC Tank Warfare community hobby forum

So here's the superstructure printed all in one go except the lower glacias which I'll add on after (for printing layout reasons). It makes the part look small, but that print area is over 16". This simplifies things quite a bit and reduces post finishing a lot too - no body work. As before, the roof and rear deck are added separately (as it was in full scale).

Looks great! A bigger printer is very handy as well, would love to have one of those!

Verstuurd vanaf mijn SM-G970F met Tapatalk

Impressive, and I guess hulls printed as a whole unit will be stronger than those bonded together later.

Thanks. Surprisingly, the way I did it in 2 pieces is just as strong or stronger as the one piece, but sure is a lot less work to do as one.

I primered up the upper hull. With a consistent coat on it it doesn't look half bad. I've no talent for painting, so now comes the hard part for me!

Send ut here mate, I will paint it for you
Could be a long delay in getting it back to you though...................

I would, but postage would be a killer! I suppose I gotta learn the painting basics some time. Irony is, I can paint a car, but hopeless at painting models.

Looking ace

Got everything primered and the tracks painted. Now picking a paint scheme for the final coat. Any suggestions?

Out of a very nice late war Mig camo book:

Thanks.. Maybe something similar to that first one would be in my wheelhouse... Won't be exact, but something similar. I got the paints, now just need to do it and onto the Stug. There's still some bits to do like hammer and shovel and whatnot, but those are common and can be done later.