Page 59 of 69
Re: The 3D Printer Thread
Posted: Mon Oct 26, 2020 8:16 am
by AlwynTurner
Hi, I bought the aluminium extruder on Amazon
and it works brilliantly. I had to change the extrusion rate to 110% because the extrusion drive rollers are smaller diameter than standard, but once I did that then the result was excellent quality prints with both PLA and PETG
Alwyn
Re: The 3D Printer Thread
Posted: Mon Oct 26, 2020 8:24 am
by Biasphere1
Gotcha I am printing well but printing wicked is the aim isn't it.
I went from the normal tube to the Capricorn and I believe I saw an improvement but who knows.I had to give it a little more retraction but to me that just told me it did work.
Cheers and THX man.
Re: The 3D Printer Thread
Posted: Tue Nov 17, 2020 5:44 pm
by midlife306
This has just arrived from AliExpress Czech warehouse, not bad for £180
Sent from my iPhone using Tapatalk
Re: The 3D Printer Thread
Posted: Tue Nov 17, 2020 5:46 pm
by Son of a gun-ner
Wow, how long did you have to wait from the time you placed the order?
Re: The 3D Printer Thread
Posted: Tue Nov 17, 2020 5:46 pm
by midlife306
Re: The 3D Printer Thread
Posted: Tue Nov 17, 2020 6:12 pm
by Son of a gun-ner
Wow, that's good, it just took B and Q three weeks to deliver a smashed hand basin.
Re: The 3D Printer Thread
Posted: Tue Nov 17, 2020 9:27 pm
by Tiger6
Son of a gun-ner wrote:Wow, that's good, it just took B and Q three weeks to deliver a smashed hand basin.
Hey now, they at least took the time to do the job properly
Re: The 3D Printer Thread
Posted: Sat Nov 21, 2020 9:05 pm
by Will01Capri
Re: The 3D Printer Thread
Posted: Sat Nov 21, 2020 10:47 pm
by HERMAN BIX
A 251/22 the best of them all !
Flat panel rear door, PaK in the back, awsome
Re: The 3D Printer Thread
Posted: Sun Nov 22, 2020 12:47 am
by jhamm
A picture of my 251/22 it is completely made of brass:
