Page 6 of 7
Re: Jagdtiger 1:16
Posted: Thu Jul 09, 2015 10:58 am
by Merlin707
Hi Chris,
Again thank you for the quick reply.
I know your point about the small hull and lack of space. I have had to cut down the inner barrel as it hits the battery and loses full depression and elevation.
Will look forward to seeing an application for the E-25.
On a side note are you in a position as of yet to look into the project we discussed off-line?
Re: Jagdtiger 1:16
Posted: Fri Jul 10, 2015 11:36 am
by chris3
hi
no problem

.
wich projekt are you talking about?
cu christian
Re: Jagdtiger 1:16
Posted: Sat Jul 11, 2015 4:02 pm
by Merlin707
Hi Chris,
I was referring to the E-90 Krokodil that we talked offline about creating.
I believe it to be the bigger badder brother of the E-25 with a 175mm KWK Cannon.
Here is the picture I sent you:

Re: Jagdtiger 1:16
Posted: Sat Jul 11, 2015 4:16 pm
by Merlin707
I was thinking you could utilise the Taigen King Tiger Lower Hull And Upper Hull minus the Turret, then build the superstructure from there as that would give a good baseline and scale?
As this would be a what if build, it very well could have utilised this setup.
Re: Jagdtiger 1:16
Posted: Sat Jul 11, 2015 7:53 pm
by chris3
hi
you want to use the kingtiger lower metal hull in my jagtiger lower hull?
cu christian
Re: Jagdtiger 1:16
Posted: Sat Jul 11, 2015 10:08 pm
by Merlin707
Hi Chris,
Apologies I think you have misunderstood me, it's the picture 2nd down from the top that is similar to the E-25 but bigger.
It's the picture above the Jagdtiger 2.
Re: Jagdtiger 1:16
Posted: Sun Jul 12, 2015 12:11 pm
by chris3
hi
oh, yes i remeber.
Sadly i didn t find the time to make the Krokodile, only the salamander is done

.
and here from a custumer.
cu christian
Re: Jagdtiger 1:16
Posted: Mon Jul 20, 2015 3:10 am
by chris3
moin
the next steps
cu christian
Re: Jagdtiger 1:16
Posted: Wed Jul 22, 2015 1:06 pm
by SCHWEREPANZER
That is looking great, Chris. We're anxious for this piece to see full light of day. Great work, as usual.
Re: Jagdtiger 1:16
Posted: Thu Jul 23, 2015 11:31 pm
by chris3
thank you
