RC Tank Warfare community hobby forum

The sound on your tank is pretty awesome, does the Tbs mini plug into the Clark board ?

WOW you did a HELL Of a job!

well done mate wish i was that good lol love the build

Hey everyone, again thanks for the kind comments, I couldn't have done this without a lot of help and resources this site provides, 'jake79' the TBS mini conects with both the receiver and Clark board, the instructions from Benedini were a little difficult to get my head around as a 'first timer' but it's not too hard, il try and get a picture up of a wiring diagram if that would be helpfull?!

If you don't mind..

Thanks, Jake

Very impresive Tiger 1, well done.
Alan

Made a little vid with my new GoPro

https://youtu.be/VIBx-EbaCak

superb well done

Good morning,
Top drawer work! One thing you might consider is removing the duplicate cleaning rod canister on the back deck, drivers side. It's a known issue with the HL and Taigen uppers.
Regards,
Painless

PainlessWolf wrote:Good morning,
Top drawer work! One thing you might consider is removing the duplicate cleaning rod canister on the back deck, drivers side. It's a known issue withe HL and Taigen uppers.
Regards,
Painless

Thanks for the tip! There are a few little bits I'd like to chance to add to the realism but I've got a new project now so the tank will prob be left alone for a while - the new project is a Tamiya 4 axle heavy haulage truck with low loader trailer to haul the tank around on