Page 49 of 69
Re: The 3D Printer Thread
Posted: Tue Jan 14, 2020 10:52 pm
by Will01Capri
If I knew dimensions then i could check
But I designing my own.metal chassis for these with dual motor units and will use a similar setup to our all trucks
Re: The 3D Printer Thread
Posted: Tue Jan 14, 2020 11:26 pm
by Tiger6
Lego Power bogie dimensions:
Wheel diameter = 17.5
Width over axle ends = 47.5
Distance between axles = 47.5
Height from rail to top of bogie = 25.5
Overall length = 86mm
Re: The 3D Printer Thread
Posted: Tue Jan 14, 2020 11:37 pm
by Tiger6
In other news:
- R975 Engine and Stand.JPG (61.7 KiB) Viewed 1166 times
- R975 Engine and Stand2.JPG (67.59 KiB) Viewed 1166 times
Not sure how well its all going to print...
Re: The 3D Printer Thread
Posted: Tue Jan 14, 2020 11:39 pm
by midlife306
Bloody hell, good luck with that Martin...
Sent from my iPhone using Tapatalk
Re: The 3D Printer Thread
Posted: Wed Jan 15, 2020 7:20 am
by Will01Capri
Tiger6 wrote:In other news:
R975 Engine and Stand.JPG
R975 Engine and Stand2.JPG
Not sure how well its all going to print...
Ooooo I like the look of that, totally cool. I just love seeing engines go from CAD to print. Looking forward to seeing your results
Re: The 3D Printer Thread
Posted: Mon Jan 20, 2020 12:45 am
by Tiger6
I think I've managed to assemble the crankcase upside down, but anybody wanting to quibble will be invited to do better...
Re: The 3D Printer Thread
Posted: Mon Jan 20, 2020 10:42 am
by midlife306
Bloody hell, that’s a cracking job Martin!!!
It had nightmare written all over it lol
Sent from my iPhone using Tapatalk
Re: The 3D Printer Thread
Posted: Mon Jan 20, 2020 11:43 am
by HERMAN BIX
I had to google it to find out what it was !
Re: The 3D Printer Thread
Posted: Wed Feb 05, 2020 8:07 pm
by Will01Capri
Big shout out to Wayne for helping me out with some tyres for the pak40.
Now it looks like i have to purchase another Ender3 and convert purely for printing tyres. Nice work
Re: The 3D Printer Thread
Posted: Wed Feb 05, 2020 9:57 pm
by Jarlath
Will01Capri wrote:Big shout out to Wayne for helping me out with some tyres for the pak40.
Now it looks like i have to purchase another Ender3 and convert purely for printing tyres.
Switching filaments is a Pita when you want to do a bunch of printing... (aka I want to use up my roll damnit...!)