RC Tank Warfare community hobby forum

Many thanks Shaun, that link will prove to be most helpful for sure. Nice work and that looks the sort of site i been looking for.

Not sure if I'm late to the party....

Building a Gaz truck with my son in kit form

The motor supplied in the kit is much larger then the pre built one I've purchased.

Just wanted to share this if anyone hasn't seen it before....

It's the long can version without the orange end.

That's great info. Thanks for sharing

Will01Capri wrote:That's great info. Thanks for sharing

you're welcome

Few of my builds then so far!
Military Hilux Truggy
Camouflage and rebuilt with light bar. Looks cool by Will Pattinson, on Flickr

GAZ 66 ShiShiga
GAZ truck by Will Pattinson, on Flickr

GAZ 66 Fire Support Truck
21462498_10157143075013009_4851794654815844859_n by Will Pattinson, on Flickr

M35A2 4x4 (in progress!) I calling big ears!
New GAZ truck 66 and test drive of M35 truck in the snow by Will Pattinson, on Flickr

M35 Rat Rod (just started)
Cutting up the M35 cab. Roof chop and also raising the mud guards by Will Pattinson, on Flickr

For each build i have put into a seperate thread to give further details. But i have to say i for one love these little trucks. They just open up a word of possibilities for not very much cash. Some of you guys builds are awesome and its great to see as it inpires my next one.

Right, i gotta get on with a 6x6 now as it eating away at me now! haha

Im not into trucks but for those who want to see videos of a build by RCMojo:

Some pics to follow but I made alloy chassis for a trailer and now just making a steel axle. Leaf springs and it should be good to go.

c.rainford73 wrote:Not sure if I'm late to the party....

Building a Gaz truck with my son in kit form

The motor supplied in the kit is much larger then the pre built one I've purchased.

Just wanted to share this if anyone hasn't seen it before....

It's the long can version without the orange end.

Have anyone tested the long motor vs the short one?
I could use some more power without adding top speed, for my little truck.

I found a video on YouTube where a guy had 3D printed a mount that holds 2 small geared motors.
I ordered a couple of these motors & printed myself a holder.
Have a look...

I’ll give it a try when I get chance, they’re only tiny motors though..
Cheers
Wayne


Sent from my iPhone using Tapatalk

I was thinking something very similar for the Prototype build I doing at the moment. Need a lot more grunt