RC Tank Warfare community hobby forum

that is a bit of a headache, i'm surprised no one does metal suspension arms for the bulldog. looking at your pic's rob, the panzer3 metal shocks do look like they will fit with a bit of a rework, have you got a good pic' of a suspension arm?, i have something in mind

                Tony

i know what your gonna say i think ::) PZ3 arms
the main problem is getting the dogs wheels off as they are glued on but ive got a method off removal good old WD40 and a lot of patience

got the adjustable idlers finished and tested and they seem to do the job loads of driving 

well the pz3 route is 1 idea, but the main idea i had was to make some in metal, i wanted to see the 'dogs suspension arms so i could see how difficult it would be to make a mold from them, i can make molds, but nothing to complicated

                Tony

well i got a spare chassis so i could pull one off and let you see
if i had a tig welder could of made some that way or even silver soldering

your mold idea sounds do-able but as you say might be difficult

i think its worth a go rob, especially as no one seems to make them, we could make a few pence off of it if it works

              Tony
ps, i got a decent mig welder(not a hobby one)

mmm sounds like an idea mate
will have a look

no worries rob, i'll ring you during the week(if ok) and we can discuss it

              Tony

no probs mate after 8.30pm tony as im on lates this week 

finally finished the cammo and started the weathering

used mig pigments old rust on the muffler shields a before and after shot

looking great mate cant wait to see it finished

Matt