Page 5 of 5
Re: Haya Chieftain desert trial version
Posted: Wed Jan 15, 2025 1:23 pm
by Herr Dr. Professor
My tanks don't get run much outside, so this may not work for you. I use E6000 (Shoe Goo) for track pads. The stuff is strong, but actually remains slightly flexible. (It dries also clear and can be sanded and painted.)
Re: Haya Chieftain desert trial version
Posted: Tue Jan 28, 2025 1:59 pm
by ongbenghui
After a number of iterations. I finally managed to reproduce a 3d printed heng long turret ring gear. This gives me additional capability to create slightly better tolerance turret gear with slightly better cable management. This has been tested on a Taigen Leopard, and the Haya Chieftain. Haya Centurion will be tested too.
Any variations of the design that you might need ?
Any thoughts ? comments ?