3D models to print

[HERMAN BIX]

They think of everything now eh!!

[jee]

They think of everything now eh!!

yep, makes it more fun, but also a bit more complicated to control

[jee]

BTR-4 in 1/16 from Inkor

https://cults3d.com/en/3d-model/various/btr-4

[jee]

from Inkor, the centurion mk III in 1/16 https://cults3d.com/en/3d-model/various ... n_zvoCfiDk

[jee]

Cromwell Mk IV in 1/6

https://www.warprints.xyz/shop/cromwell ... rrency=EUR

[Fabianm5]

Hi there,

just a question, what's a good 3d-printer to print scale 1/6

[jee]

Hi there,

just a question, what's a good 3d-printer to print scale 1/6

Hi Fabian,

Maybe you can ask your question better here: viewtopic.php?t=14690&start=680
But it is mostly depending on how the model is "cut" in pieces, often the designers tell what the minimum size buildplate is which will be necessary.

[jee]

A jagdtiger in 1/16 from Inkor: https://cults3d.com/en/3d-model/various/jagdtiger

[Fabianm5]

Hi there,

just a question, what's a good 3d-printer to print scale 1/6

Hi Fabian,

Maybe you can ask your question better here: viewtopic.php?t=14690&start=680
But it is mostly depending on how the model is "cut" in pieces, often the designers tell what the minimum size buildplate is which will be necessary.

I shall look at that topic.

Thank"s Jaap. (En is het al koud daar?)

[jee]

Hi there,

just a question, what's a good 3d-printer to print scale 1/6

Hi Fabian,

Maybe you can ask your question better here: viewtopic.php?t=14690&start=680
But it is mostly depending on how the model is "cut" in pieces, often the designers tell what the minimum size buildplate is which will be necessary.

I shall look at that topic.

Thank"s Jaap. (En is het al koud daar?)

Great!
Het is hier nu rond het vriespunt, 's nachts vriest het
zal wel snel veel kouder worden hoor, normaal gesproken is het gemiddelde -20