Hooben T55a Build

subdvr · Post by **subdvr** » Tue May 24, 2011 6:56 pm

Hey Brian,

If you really want a challenge, check this out, Up For Sale: http://www.mortarinvestments.eu/products/tanks-2/t--36 not bad at £35K

Would think it would sting a little filling it up with prices as they are right now!

Trev

brizo58 · Post by **brizo58** » Tue May 24, 2011 7:41 pm

Hi Trev
Yep get the wife to buy it for my 60th next jan

,like that on the driveway

.....Brian

brizo58 · Post by **brizo58** » Thu May 26, 2011 8:34 pm

Hi Trev
Just an up date on the tank,Just been working on the loader,s hatch the kit ones to thin

and detail is not there it should be three times as deep with a cut out for the locking handle and 5 holding bolts it"s come out quiet well.I think it"s like that to match the turret roof armor thickness.i"ll get some photos of it for you,if you want to do the same

,Best Regards...Brian

.....

subdvr · Post by **subdvr** » Fri May 27, 2011 5:55 pm

Sounds good Brian, ive been having a good nosey round the following links, definitely some room for adaptation on mine: http://www.primeportal.net/tanks/jose_l ... php?Page=1 and also: http://www.primeportal.net/apc/jussen/t-55a.htm

Would be nice to see yours :~

brizo58 · Post by **brizo58** » Fri May 27, 2011 6:57 pm

Hi trev
Heres two pics hope they help

IMG_0257.JPG

......Brian.

brizo58 · Post by **brizo58** » Fri May 27, 2011 7:03 pm

Hi again trev

I forgot to say

got my MF06 and com cable today but no TO.8 yet

i ordered the MF06 after TO8

so hope to get it tomorrow????.....Brian...

subdvr · Post by **subdvr** » Fri May 27, 2011 7:04 pm

Hi Brian

Looks great, what did you use for the new piece, ive looked at polystyrene but its difficult to get it smooth

brizo58 · Post by **brizo58** » Fri May 27, 2011 7:15 pm

HI trev
Two good sites there

i see on one of them that the driver"s hatch has no lip around it!! i took mine off but wasn"t sure i done the right thing???.Nice to see i got it right

the lip on it did not look right.Still it"s nice to have all the pics

.....Brian

brizo58 · Post by **brizo58** » Sat May 28, 2011 8:54 am

Hi trev
Well geting a bit fed up about this DMD unit it"s been in the coventry parcelforce office for 3 days

it says it"s {awaiting presentation to customs commissioner}

.What that means i have no idear

Still thats our post service for you

.Keep you posted

....Brian

brizo58 · Post by **brizo58** » Sat May 28, 2011 8:57 am

Hi trev
Yep used plastic card 2to 3mmx3 then sand down smooth.....Brian

RC Tank Warfare community hobby forum

Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build

Re: Hooben T55a Build