Page 4 of 6
Re: Tamiya Centurion finishing
Posted: Fri Jul 28, 2023 10:03 pm
by jarndice
A lovely job of work,Envious,
Did you buy the .50 mg mount seperately and if so where from?
I got the .30 mounts from "Shapeways" but the .50 mounts did not seem to be available.
Re: Tamiya Centurion finishing
Posted: Sat Jul 29, 2023 6:42 am
by Ad Lav
Thank you - it’s almost there now.
The .50 cal is from Tamiya with a brass Aber barrel.
I believe Colin (my 3D printing wizard) is printing .30 cals and mounts. I’ll post a photo.
Re: Tamiya Centurion finishing
Posted: Sat Jul 29, 2023 6:54 am
by HERMAN BIX
Yeah this has really got it going on
Your wizard will be getting a request off me at some point.
Re: Tamiya Centurion finishing
Posted: Sat Jul 29, 2023 7:01 am
by Ad Lav
Enough details added to make it different!
Lee (modelbuilder4) had some parts of him, including the Jerry cans which are lovely.
Shout when you are ready
Re: Tamiya Centurion finishing
Posted: Sat Jul 29, 2023 7:04 am
by Ad Lav
Lower hull is almost finished.
Sent from my iPhone using Tapatalk
Re: Tamiya Centurion finishing
Posted: Sun Jul 30, 2023 1:45 am
by John Glover
That 3 D printing gives you the ability of fine detail. Beautiful work. Regards John.
Re: Tamiya Centurion finishing
Posted: Sun Jul 30, 2023 4:28 pm
by Ad Lav
Thank you John.
The resin printing is something else. Far superior to pla for the details stuff.
Re: Tamiya Centurion finishing
Posted: Sun Jul 30, 2023 4:30 pm
by Ad Lav
Turret almost finished
Sent from my iPhone using Tapatalk
Re: Tamiya Centurion finishing
Posted: Sun Jul 30, 2023 9:29 pm
by Ad Lav
Re: Tamiya Centurion finishing
Posted: Sun Jul 30, 2023 10:49 pm
by Ad Lav
Tracks to weather next - more paint needed!
