Re: s.I.G 33 Converion
Posted: Sat Dec 03, 2022 5:11 pm
I've not been working on the tank for a while as I'm making a heater unit for my resin printer to allow me to do better prints now it's turned colder but I have designed some new hatch doors with detail added that I can print on the resin printer with the abs type resin but can't print them until I've finished the heater.
I have fitted the engine covers and temperately fitted the rear deck parts to see what they look like fitted and to see if any changes are required.
And it's looking not bad at all I've just got some fresh milliput and will try to make the checker plate look better where the moulded tools were removed.
I am also going to work on the 2 vents at the side of the rear deck by Dremeling them out and adding a bit of plasticard and etched grills to get them ready to fit back on.
Now to finish the heater so I can print the new hatches to fit.
I have fitted the engine covers and temperately fitted the rear deck parts to see what they look like fitted and to see if any changes are required.
And it's looking not bad at all I've just got some fresh milliput and will try to make the checker plate look better where the moulded tools were removed.
I am also going to work on the 2 vents at the side of the rear deck by Dremeling them out and adding a bit of plasticard and etched grills to get them ready to fit back on.
Now to finish the heater so I can print the new hatches to fit.