Page 3 of 3
Re: HL TK-6.1S kit.
Posted: Thu Jun 03, 2021 7:18 pm
by 971wright
Hi Guys if you want to fit smoking gun and FPV camera you will have to piggy back the Wifi conection, it is the only one with the correct voltage for the camera,and the one the smoking gun needs dont forget to put a jumper lead into the cn6.
Re: HL TK-6.1S kit.
Posted: Thu Jun 03, 2021 10:25 pm
by HERMAN BIX
What gets me is why there is no jumper cable in the kit ?
Assuming most of these are going into older version tanks, they all need one
Re: HL TK-6.1S kit.
Posted: Thu Jun 03, 2021 11:26 pm
by 971wright
Hi you need Jumper if you remove the BB and fit a recoil.
Re: HL TK-6.1S kit.
Posted: Fri Jun 04, 2021 2:26 pm
by 43rdRecceReg
HERMAN BIX wrote:What gets me is why there is no jumper cable in the kit ?
Assuming most of these are going into older version tanks, they all need one
I've yet to try it, but in the days when I built PCs, I often used two-pin jumpers on the bios chip. I wonder whether one would fit on CN6?

Then again, it's easy enough to make one, but agree it would be nice if one were included.
Another thing to bear in mind is, as I discovered when wiring my Comet up, the IR receiver arrives with a three-pin JST type connector (suitable for the V6.0 MFU); but the 6.1s unit actually requires a three-pin flat servo connector.
Re: HL TK-6.1S kit.
Posted: Fri Jun 04, 2021 3:12 pm
by abramsky
Is it really so hard to make such a jumper yourself
For example, such as:
It only takes a few minutes of work and costs almost nothing ( OK maybe a few cents ).
When I know the price you are willing to pay for a set of "original" HL cables, I start to think about producing them myself ...
I will do it cheaper and with better quality cables than those from HL
