Page 3 of 5
Re: Need a answer
Posted: Thu Sep 19, 2019 1:34 pm
by Chrizh
Max-U52 wrote:I just sent you a PM so hopefully you'll be able to reply.
Replied. Had to go on the laptop. Forum doesn't like Samsung's mobile browser it would seem.
You were correct though. Soon as I plugged that 2pin in to the 5pin, I had track recoil and sound.
Re: Need a answer
Posted: Thu Sep 19, 2019 2:00 pm
by Son of a gun-ner
Chrizh wrote:Forum doesn't like Samsung's mobile browser it would seem.
I use the Google browser on my Samsung phone, never get a problem with the forum.
Re: Need a answer
Posted: Thu Sep 19, 2019 3:31 pm
by Max-U52
I am also using the Google Chrome browser on my Samsung phone, and I never have any trouble.
Re: Need a answer
Posted: Thu Sep 19, 2019 7:07 pm
by Chrizh
Put Google Chrome on my phone, still no good! Same errors. Weird. Have emailed board admin anyway.
Re: Need a answer
Posted: Thu Sep 19, 2019 10:01 pm
by 43rdRecceReg
Ragnar wrote:Max-U52 wrote:43rdRecceReg wrote:
If you look at
'Step 6' of the Airsoft wiring for 360 deg turret I posted, Gary, and Chrizh, you'll see that the white/orange connector goes into the 5 pin terminal on the Motherboard.
Right, you put the two pin plug on the two left-most pins in the five pin socket, or he PMs me and I'll send one of these. It plugs securely into the five pin, and it's a lot easier to connect the two pin to the little socket, instead of jamming it into the five pin.
43rd RR
It would be great if you’d post a picture of the inside of the upper hull you reinforced the next time you chance to open it up , like to see how you made your cuts and fitted the plastic sheet.
Larry
As per your request:
This was taken in low light conditions, Larry. I have a brilliant wee hole cutter now, but at the time I cut the plasticard sheet for the Tiger, I didn't. Still, the card reinforcement works well.
- Metal turreted Tiger reinforced with plasticard sheet.
Re: Need a answer
Posted: Thu Sep 19, 2019 11:18 pm
by Ragnar
Nicely done!
Re: Need a answer
Posted: Thu Sep 19, 2019 11:46 pm
by Ragnar
Nicely done!
Re: Need a answer
Posted: Fri Sep 20, 2019 12:07 am
by Max-U52
I wonder if the brace from the King Tiger could be adapted?
Re: Need a answer
Posted: Fri Sep 20, 2019 9:22 am
by Jofaur86
Hello
Yes fesable,on a KT Tam. Voici what I did on mine,aluminium 1.5 mm
Re: Need a answer
Posted: Fri Sep 20, 2019 11:27 am
by Max-U52
I like that aluminum plate. Very clean looking job. I'm going to ask Eric for some of the braces from the KT and the panther to see if I can adapt them to a tiger. We'll see what happens.