RC Tank Warfare community hobby forum

Hi Vonrundstedt ,
Thanks for the comments . Its taking some time to get this done . Ive got my Pz III / Stug III Ausf G to finish I started this before HL bought there one out  :-\ .

Thanks Andy

Hi Ern, Thanks for the comments yer the free times good but no £/$ coming in ! I want to get this finished as far as I can then get my Stug finished thats sat in my dads workshop for a long time I started this before HL bought there Stug out  :-\ . I will PM you regarding the parts .

Thanks Andy

I have finished the rear end of the tank now and primed it . The jack holder Im not 100% sure about yet ?

Heres some more pictures of the rear convoy light . I put some bluetack over this when I sprayed it , so Im going to have to touch it up around the fibreoptic cable ends ? Again it looks brighter than it is in the picture.

Just a few more shoots showing the rusty exhausts , side skirts thinned down and with battle damage , the two bolt escape hatch hinge .

It's looking awesome Andy! Coming along fast. The convoy light looks awesome!

Rik

Hi Rik, Thanks for your comments . Im impressed with your Tamiya Tiger to . Looking forward to the next photos .

All the best Andy

Im experimenting with producing a recoiling barrel . As Im out of work Ive used a second HL extended barrel to do this , thanks Brel . I have removed the barrel and extension piece , drilled out the sleeve to take the barrel . But later decided to take a fraction more out so I can fit a brass sleeve inside the sleeve/mantlet . This should help the barrel recoil smoothly . As for the barrel Im not sure if to extend what I have or simply make another extension piece to extend the barrel to the required length . As this will be metal hopefully it will recoil ok . I have yet to buy a recoil unit  However Id like to know which cable powers the recoil as I have the gun elevation still wired but the BB firing will want re wiring ??????????.

I have decided to leave the metal extension on the plastic HL barrel and have now added another metal extension piece . This I will try once I sort the recoil unit out .

I have done a little more to my Tiger . I have altered the two front superstructour points were the c hooks hang on to late war stlye and added the frontal zimmerit . Ive also added some more zimmerit were I dont think Ive seen it done before ? ( on the tank that is  ) I will post some pictures during next week . Ive nearly done . I have to make my Aber clasps , tool holders  :-\ :-\ :-\ been putting this of realy , sort out the tools on the deck decide the best way to make or buy the tow cable and cleaning rod holders. And decide the best way to adjust the Asiatam suspension arms ? Then its spraying time . I do have to get a RX18 board , recoil unit and a battle system yet to .

More to follow soon . Just been busy with Chunks Tiger