Re: Missing filament in outer surface - Z axis problem
Posted: Fri Apr 06, 2018 3:00 pm
Alwyn,
I have to confess that I was too lazy to install those blue or yellow strips on my CR-10S when it came.......actually, i think I tossed them in the trash.......
...well, sometime, good things happen by accident.......
Best Wishes!
Springman
I have to confess that I was too lazy to install those blue or yellow strips on my CR-10S when it came.......actually, i think I tossed them in the trash.......
...well, sometime, good things happen by accident.......
Best Wishes!
Springman