Ibu2 pro/er9xr pro HELP!

[Tigerjim]

I have already flashed it with the new firmware it was the reason I choose the pro, do you think it will need flashing again?

Cheers Jim

[Tankbear]

The firmware is just part of it Scalawag has provided me with a setup file for the Pro which has everything already done. So if you PM your email address I will send it across to you.

Ian.

[Tigerjim]

Thanks Ian, I've sent you the pm, I also tried Anzio in tx it doesn't work, tx won't pick it up, and also fresh sd card (fat16) with fresh ini file on it, again it's same result, also had a look at eepe tx doesn't register on that either and I can't see the tx in device manager but I supect that's a driver issue.

Cheers Jim

[Tigerjim]

Ok, so I thought I'd post an update for those who may have similar issues as I have, first of all thank you tankbear and scalawag your support has been first class .

Note to myself and all who's reading ALWAYS READ THE MANUAL!, the 9xr pro uses eepskye not eepe to talk to a Pc. My tank now moves and works, excluding a few issues, the tank turns one way a lot faster than the other! And also forward and back was also left and right on the right stick I've temporarily sorted that by swapping the servo leads from channel 1 to channel 2 but everything else seems to work now. This was all achieved by slaving in a 7.2 Nicad and flicking the dip switches then configuring once that worked the dip switches were then set to the original positions for a 3s lipo, crude but it works.

Another problem I've had is the sound both on the main board and the tpa, basically it was so quiet it made my old Henglong tiger sound like a beast, I don't have the old sound pot from my scrapped tiger as I set fire to it (don't ask), so I looked at the Ibu manual and it says to use a 10k 100mw pot so I did, and I couldn't hear the tank over the gearboxes, after some head scratching I added a 1.7k resistor in series to the signal line the sound difference is dramatic! So I'm gonna swap out the pots for 20k ones so i have more control.

Jim