Page 3 of 3
Re: Servo Operation
Posted: Sat Feb 28, 2015 6:37 pm
by MichaelC
Good stuff Richard!
Re: Servo Operation
Posted: Sat Feb 28, 2015 6:44 pm
by Trailbiker
Michael, I ended up using one of the very short arms on the servo and just bent the rod through it. This seemed to work much better than my previous system, whereby I had another little ball joint on the end.
Re: Servo Operation
Posted: Sat Feb 28, 2015 9:14 pm
by MichaelC
Yup and that would reduce your pull angle as well. I am still curious to see other IBU servo recoil constructions as I always find the Clark ones not quite deep enough for my liking.
I also need to start trying this bent rod business as I have seem couple of them working quite well. I tend to over-engineer on the pull rods/linkage arms.
Michael.