RC Tank Warfare community hobby forum

242 hi just cut wires and join them together with the 3pin at one end just remember which is recoil ,, and when you plug it in make sure the 3pin is right way round Ray

hi rayzzer ,I try`d that with the three wires from the bb gun wich were black, red, white , but I either got recoil & no elevation , or elevation & no recoil if I connected red to red , yellow to white , green to black , I got recoil no elevation , iff I connected red/ red green /white ,& yellow/ black then I got elevation no recoil,tanker 242

ps thick black to ground , & blue to white on asiatam red/ black flash micro switch to m/g port on 2.4 ghz unit .tanker 242

think you may have falt in the circuit '' id take three new wires from tree pin on hull and to motors see if that do it .. and check the 8 pin on hull that contracts sound ..

Ed picture of my unit wires at motor ..

hi rayzzer ,my wireing is the same red &green from the elevation motor yellow from the recoil motor yellow connected in from recoil motor to micro switch with black wire from micro switch to negative battery I have removed the blue wire & connected white wire between recoil & elevation motors so wireing is same as in photo, I have connected red yellow &green wires to a three pin to plug in to hull top, now I have constant elevation but no recoil , iff I disconnect the green constant elevation stops but still no recoil [ 8 pin contacts are sound]

So now we know the motors are ok wiring ok looking like it's in the M.F.U . Try swaping from a spare "" or try connecting to a a sound tank you no works ...

hi rayzzer, with your help & that of KTrob & MichaelC I have it figured out now, the problem turned out to be with the red & yellow wires in the three pin plug, they needed to swap places the[ correct way ,red to pin 4, yellow to pin 5, green to pin 6,] instead of the wrong way [ red to pin5, yellow to pin 4, ] tanker 242.

Hi Tanker glad you got it sorted