Page 20 of 54
Re: Tanks to print
Posted: Fri Dec 16, 2022 10:22 pm
by HERMAN BIX
How about an ISU 122 with the long barrel ?
Re: Tanks to print
Posted: Sat Dec 17, 2022 4:57 am
by tankme
HERMAN BIX wrote: ↑Fri Dec 16, 2022 10:22 pm
How about an ISU 122 with the long barrel ?
You can choose the 152 or the 122 with Inkor's version which is already available on Cults:
https://cults3d.com/en/3d-model/various/isu-152-122
Re: Tanks to print
Posted: Sat Dec 17, 2022 5:44 am
by HERMAN BIX
Re: Tanks to print
Posted: Sat Dec 17, 2022 2:34 pm
by Tmc132
good idea. I'm going to discuss it with the designer, who is open to suggestions.
Re: Tanks to print
Posted: Sat Dec 17, 2022 10:35 pm
by HERMAN BIX
An ISU122 that is compatible with a Taigen lower would be ideal.
Anyone that has a JS2 already can make themselves a 2 in 1 set with very little alteration. Especially if a set of electronics to operate the gun is pre installed.
Just an idea based on purely selfish needs !!
Re: Tanks to print
Posted: Sun Dec 25, 2022 6:01 am
by tankme
Re: Tanks to print
Posted: Tue Jan 03, 2023 2:15 am
by jee
Re: Tanks to print
Posted: Tue Jan 10, 2023 12:43 am
by jee
Re: Tanks to print
Posted: Tue Jan 10, 2023 3:18 am
by jee
Re: Tanks to print
Posted: Wed Jan 11, 2023 3:50 am
by jee
All from the same designer:
Small Conversion Kit for a Sd.Kfz. 251 APX turret Version
https://cults3d.com/en/3d-model/game/sd ... ersion-kit
Marder I on Hodgkiss chassis full set
https://cults3d.com/en/3d-model/game/ma ... s-full-set
update for the Hodhkiss chassis to Marder I
https://cults3d.com/en/3d-model/game/ma ... dd-on-only
