RC Tank Warfare community hobby forum

Belly Armor update, 4/16.

The end is in sight, I am approaching the finish line!











Next up, the side ARAT (Abrams Reactive Armor Tiles) and their mounting.

TAFN,
Barry

Non scale drawing of how I have envisioned the skirt mounted Reactive Armor Tiles. I am thinking brass sheet and rectangular tubing for the primary structure.

More to come

Belly Armor, update 4-17-16

Added the aft end fascia piece. Ended up that instead of adding a “wedge” shaped piece it required cutting back the end of the main section and mounting a piece the same as was done on the front piece.

Mounting Rails nearly complete, all that remains are some final sanding to round off the edges of the hull attachment hangers and the attaching the bolt heads. Still not sure exactly what is the best way to attach the rails to keep the front piece of belly armor separate. I want to glue the rails to the main section of the belly armor but that will leave the front 1” unattached to both the armor and hull. I may have to actually use threaded mounting bolts.

Here are some photos, first a couple of close ups then a “walk around” sequence.

Thanks for looking,
Barry

Walk Around sequence:

Lookin' good Barry...I have got to get some free time to get movin' on mine!

Thanks Cody,

I am pretty pleased with how it has turned out. Once it is sanded smooth and corners rounded I will add the weld bead on the front and rear fascia plates, then the bolt/washed heads. I think it will look the part.

Yes, you need to get cracking!

Barry

Here is my rendering of the ARATs and their mounting. I will use as much of the existing side skirts to give me a solid structure to build on..

TAFN,
Barry

Another productive weekend!

I made the final changes to the hull side doublers by opening up the slots for the suspension arm anti rotation studs. I closed them out with individual pieces of .040" styrene glued into place. I then bonded them into place using Loctite Epoxy Plastic Bonder then glued the suspension tower reinforcements into place using Ambroid Pro Weld. Then the main pieces were also screwed into place and as an added reinforcement a full length .080 x .250" strip was glued along the upper edge.

If they shift it will be cause something "bad" happened!

Thanks for looking in,
Barry

It looks fantastic, Barry! Very precise, clean work.

Cheers, Tom

I just noticed....

Why is your M1 green? Did HL sell a green M1? Mine is desert even inside.