RC Tank Warfare community hobby forum

No new progress. Working 2 jobs at the moment and it turns out I now have bloody
Shingles ! This getting older is for the birds! Off to the VA hospital tomorrow to get it sorted
And then hopefully I can work on the tiger some more.

Markocaster wrote:No new progress. Working 2 jobs at the moment and it turns out I now have bloody
Shingles ! This getting older is for the birds! Off to the VA hospital tomorrow to get it sorted
And then hopefully I can work on the tiger some more.

SHINGLES??????????????????? ...dang... you better get crackin on your tanks... too much stress buddy.... tanks are the best way to ease stress

Take care dude

ALPHA

Hey mate, I see you are back.
Assuming you are ok for the record...................the Tiger ?...........hows the Tiger

Built a shelf in the garage today to store the tanks.
Sure been slow going lately. But I will finish it

Great to see you're around mate
You will get there, once life waits up a bit eh

It's been ages and ages since I last posted. Tonight I was messing around w the Clark TK 22
Board. I set it up as per the Clark web page and I get nothing. I think it may be a radio / receiver issue. It's got the proper specs but I haven't hooked anything like this up before. I am getting power the little fan spins but that's it. No movement at all? Any advice appreciated, I haven't a clue when it comes to r/c that's my weak link.
Some photos of my set up




At the moment I just want lower hull power and then will add servo recoil.

Kiaser wrote: where your on/off switch is the one beside it which is the smoker there should be a jumper on the two pin plug .

I think the jumper comes later with the turret / battle system, right now I just want it to move , period thanks for the suggestion. You may be right I will keep poking around
Cheers
Mark

Kiaser wrote:Yes there should be a jumper plug in the 2 pin also to complete the circuit and If you need a pic I will pull mine out for you to have a look but there should be a jumper plug that sits in there that came with the board

And a jump plug which is used on the servo connector pins .

I have so much to learn

Kiaser wrote:See the little red jumper in the two pin smoker plug have a look at picture .

Think I've got it , will have a go and check in later. Thanks for the photos

Thanks Kaiser for the info. I am so bad at the r/c part of this hobby , I may be in over my head with this and have considered getting a taigen r/c set and using that. Plug and play I can do
Maybe it should just be a static model
I spent a bit more time on some details , assembling the tow cable attachments



Cheers
Mark