RC Tank Warfare community hobby forum

Posted: **Tue Feb 12, 2019 5:55 pm**

Hi Will, I wish I’d sliced the roof off, it’s like watching paint dry at 0.06 layer height!!!
I’m sure it will be worth it in the end

The grill on the other hand is flying along & should be finished soon

Cheers
Wayne

Sent from my iPhone using Tapatalk

Posted: **Wed Feb 13, 2019 5:45 pm**

46 hours 19minutes in & 72.5mm up, 73% done...

Cheers
Wayne

Sent from my iPhone using Tapatalk

Posted: **Wed Feb 13, 2019 5:58 pm**

Would printing it upside down have been easier?

Posted: **Wed Feb 13, 2019 6:01 pm**

There are ribs on the curved roof so it would have looked bad, the floor would have needed supporting anyway. I’ll cut the roof off next time

Sent from my iPhone using Tapatalk

Posted: **Thu Feb 14, 2019 12:20 am**

53 hrs in, 87mm up, 85% done..

Cheers
Wayne

Sent from my iPhone using Tapatalk

Posted: **Thu Feb 14, 2019 12:31 am**

Almost there... Stay on target... Stay on target!

Posted: **Thu Feb 14, 2019 12:35 am**

Wayne, why are you printing a church organ

Posted: **Thu Feb 14, 2019 1:08 am**

Hehe, it’s the support material to hold the roof up

It will be finished tomorrow yay...
Cheers
Wayne

Sent from my iPhone using Tapatalk

Posted: **Thu Feb 14, 2019 1:09 am**

I knew

Posted: **Thu Feb 14, 2019 1:11 am**

I believe you

Sent from my iPhone using Tapatalk

HL Truck Mods