HL Truck Mods

midlife306 · Post by **midlife306** » Tue Feb 12, 2019 5:55 pm

Hi Will, I wish I’d sliced the roof off, it’s like watching paint dry at 0.06 layer height!!!
I’m sure it will be worth it in the end

The grill on the other hand is flying along & should be finished soon

Cheers
Wayne

Sent from my iPhone using Tapatalk

midlife306 · Post by **midlife306** » Wed Feb 13, 2019 5:45 pm

46 hours 19minutes in & 72.5mm up, 73% done...

Cheers
Wayne

Sent from my iPhone using Tapatalk

Roboticus_Prime · Post by **Roboticus_Prime** » Wed Feb 13, 2019 5:58 pm

Would printing it upside down have been easier?

midlife306 · Post by **midlife306** » Wed Feb 13, 2019 6:01 pm

There are ribs on the curved roof so it would have looked bad, the floor would have needed supporting anyway. I’ll cut the roof off next time

Sent from my iPhone using Tapatalk

midlife306 · Post by **midlife306** » Thu Feb 14, 2019 12:20 am

53 hrs in, 87mm up, 85% done..

Cheers
Wayne

Sent from my iPhone using Tapatalk

Roboticus_Prime · Post by **Roboticus_Prime** » Thu Feb 14, 2019 12:31 am

Almost there... Stay on target... Stay on target!

Post by **Son of a gun-ner** » Thu Feb 14, 2019 12:35 am

Wayne, why are you printing a church organ

midlife306 · Post by **midlife306** » Thu Feb 14, 2019 1:08 am

Hehe, it’s the support material to hold the roof up

It will be finished tomorrow yay...
Cheers
Wayne

Sent from my iPhone using Tapatalk

Post by **Son of a gun-ner** » Thu Feb 14, 2019 1:09 am

I knew

midlife306 · Post by **midlife306** » Thu Feb 14, 2019 1:11 am

I believe you

Sent from my iPhone using Tapatalk

RC Tank Warfare community hobby forum