Page 13 of 17

Re: Coolbank M5A1 stuart!

Posted: Sun Jun 09, 2024 8:47 pm
by tankme
Ecam is correct. They are grousers. They bolt onto the tracks to add traction in mud or snow.

Re: Coolbank M5A1 stuart!

Posted: Sun Jun 09, 2024 8:50 pm
by JohnWhyte
tankme wrote: Sun Jun 09, 2024 8:47 pm Ecam is correct. They are grousers. They bolt onto the tracks to add traction in mud or snow.
I wasn't sure what they was only that they was part of the tracks so thanks

Re: Coolbank M5A1 stuart!

Posted: Sun Jun 09, 2024 8:56 pm
by tankme
They use the hollow sides of the M5 track pins to insert in the ends:

https://www.milweb.net/webvert/99710

Re: Coolbank M5A1 stuart!

Posted: Sun Jun 09, 2024 9:01 pm
by Kaczor
One note - Stuart was equipped with 34 grousers in total (mounted on every 4th track) so there weren't probably enough of them to cover the hull like this ;)

Re: Coolbank M5A1 stuart!

Posted: Sun Jun 09, 2024 9:14 pm
by JohnWhyte
Kaczor wrote: Sun Jun 09, 2024 9:01 pm One note - Stuart was equipped with 34 grousers in total (mounted on every 4th track) so there weren't probably enough of them to cover the hull like this ;)
Yeah but you don't know how many was either borrowed or acquired from other tanks bit like the extra wheels and tracks used as extra protection

Re: Coolbank M5A1 stuart!

Posted: Mon Jun 10, 2024 6:17 pm
by Kaczor
As I suspected, the problem is not the transmission but the electronics. I connected the Beier to the test and immediately the model runs slower ;)
phpBB [video]

Re: Coolbank M5A1 stuart!

Posted: Mon Jun 10, 2024 8:06 pm
by Ad Lav
Nice :)

Re: Coolbank M5A1 stuart!

Posted: Mon Jun 10, 2024 8:57 pm
by tankme
Kaczor wrote: Mon Jun 10, 2024 6:17 pm As I suspected, the problem is not the transmission but the electronics. I connected the Beier to the test and immediately the model runs slower ;)
phpBB [video]
Good to know. Did you sand the Chevrons down or just run the hell out of it on concrete? :)

Re: Coolbank M5A1 stuart!

Posted: Mon Jun 10, 2024 9:01 pm
by Kaczor
tankme wrote: Mon Jun 10, 2024 8:57 pm Good to know. Did you sand the Chevrons down or just run the hell out of it on concrete? :)
Nah, it's just optical illusion. But when they are worn off, I will glue on rubber pads ;)

Re: Coolbank M5A1 stuart!

Posted: Wed Jun 12, 2024 4:36 pm
by RKRC
Image
I need help how did you get it apart I can only see two screws at the back??