RC Tank Warfare community hobby forum

You can be sure that iam mad enough (maybe too much) but...good luck with that rescaling, guys

Hi,
i have one 1/16 KIT for sale.
It contain 200 printed parts, 240 printed tracks links with pins and 345 pieces of various hardware.
There is everything for the building inside, including 4 servos and drivetrain.
Excepting control unit, receiver, transmitter, battery, smoke and sound effects.
You can see included hardware on the list below.



Including:
-detailed parts printed with DLP printer
-biggest surfaces are coated with XTC-3D
-all hatches openable
-servo controlled vertical and horizontal movement of the canon
-servo controlled recoil
-movable gunners sight coupled with gun
-alternative (simple) canon for low-end control units
-360° rotating machinegun
-ready for easy installation of the smoke generator
-LED light for the front light
-tracks tensioners
-working suspensions
-detachable spare track links
-rubber rims of roadwheels
-IR adaptor for HL/Torro IR battle system


(this is the picture of the older kit without DLP parts)

Here is complete assembly guide.Read for more informations about build.
https://drive.google.com/open?id=18LCJD ... Z1xlfTM2r5

Price is 330€ including shipping cost.

Wowzers, I’ve just had a speed read of the build instructions, what an absolutely fantastic job you’ve done there
I really looking forward to when you get around to offering the .STL’s for sale!
Good luck with the sale, it’s a real good deal at that price
Cheers
Wayne


Sent from my iPhone using Tapatalk

I just did the same. Awesome job!

Thank You very much.
I am doing my best.
Kit was sold within few hours.
Next one will be ready within few days.
I am going to spend money from that kits to complete my website.Then i am going to release STL files.Finally.

Another KIT available

viewtopic.php?f=18&t=29027

Hi,
i have decided to release STL files for forum members.
Its not a official release - its for the forum members only.
PM me to get the files.
Price: 55€

Here is the Printing guide:

https://drive.google.com/open?id=1orbg- ... svGUdBGvZj

and Assembly guide:

https://drive.google.com/open?id=18LCJD ... Z1xlfTM2r5

Files are suitable for every 3D printer with 0,3mm nozzle and 200x200x200mm printing area.
Check that guides for more informations about printing and assembly.

I purchased the STLs, from 50koruny, I am no expert, but I have seen many 3D models and I have looked over almost all the files provided and they look excellent.
I have printed a few out and they are great. I even purchased a new 3D printer for the project. As soon as it arrives I plan on printing it as soon as my SSYMS project is finished.

Again great work on a worthy subject.

Steve

50Koruny can I buy these files and scale them up ?
Just the hull and fittings not the gearbox and motors.
Make a say 1/6 scale and I will fit my own internals.
Excellent work mate.

Biasphere1 wrote:50Koruny can I buy these files and scale them up ?
Just the hull and fittings not the gearbox and motors.
Make a say 1/6 scale and I will fit my own internals.
Excellent work mate.

You sure can, for 1/6 you’ll need a creality cr10 S4 or equivalent
Longest print was 8 days










Sent from my iPhone using Tapatalk